|
- To begin installing the WaterFall system, start at one end of a gutter. Take the top edge of the WaterFall (Fig. A) and slide it under the first row of shingles on the roof.
Note: it may be necessary to slide the top edge under the second row of shingles if the edge of the roof or nails are in the way.
- Once the entire top edge is under the shingles, pull the front edge of the WaterFall system down so that it snaps onto the front edge
of the gutter (Fig. B). To get a better hold on the WaterFall product, you may want to insert the claw end of a hammer into the lower channel of the WaterFall and then gently pull it forward and along the channel to secure the entire lineal section (Fig. C).
If you have difficulty in fitting the WaterFall over the front edge of the gutter, simply bend the gutter lip up slightly until the WaterFall fit is snug on the gutter (Fig. D). Leave approximately a 1" space between the end of the gutter and the end of the WaterFall system to allow for expansion and contractions due to temperature variation. Follow directions to properly install end caps at the end of the gutters.
- Install the next lineal of the product using the same method as described in step #2. It is important to leave 1/2" space between
each installed lineal to allow for product expansion and contraction. Next, snap a connector clip over the 1/2" space between each lineal (clip optional).
- Repeat steps until the entire gutter length is covered by the WaterFall system.
|
Dealer/Installer Information
CONTACT