 |
- To obtain the best inside or outside corner fit it is suggested you use a miter box. The WaterFall product should be cut while it is
held in place at an angle that simulates the same angle it sits on the gutter. This is best accomplished by folding the top edge back at the flexible hinge so that the channeled surface is on an angle.
(Fig. E) The WaterFall can now be mitered to fit the desired corner by cutting through both the channels and top edge surfaces.
Note: The top edge may require additional trimming, depending on the exact angle desired. Also, it is good practice to install diverters at the bottom of long “valleys” created by two roof sections meeting at an inside comer.
There is no rule of thumb for this; simply it is a solution if water flow at valley is too much for WaterFall to handle. You may also choose to have that small portion of gutter uncovered to handle the increased water flow.
Note: The WaterFall end cap can also be used to join a miter cut at a corner. Slide the tabs over each piece of WaterFall.
Note: All installations should provide for a 35 to 40 degree pitch
on the surface of the gutter guard. The following accessory items must be used for the following types of gutter:
- 6" K-style gutter – 6" K adapter.
- 5" Half round gutter – Half round gutter clips.
|
BACK
Dealer/Installer Information
CONTACT